APK-280DS Twin-Output Doypack Machine — Two Pouches per Cycle

Two lanes of stand-up pouches from roll film, 90 to 120 a minute

One product, one pouch size, and more pouches a shift than a single lane can give. This machine forms, fills and seals two stand-up pouches side by side from roll film, so output doubles without the line running faster. The trade-off: pouches up to 140 mm wide per lane, and a 10.1 m line.

1. Speed: 90 to 120 pouches a minute, two per cycle

2. Pouch size: 90 to 140 mm wide per lane, 110 to 250 mm long

3. Zipper version: zipper unwound from its own reel on each lane

4. Line length: 10.1 m, 15.5 kW — the longest and most power-hungry in the range

Is the APK-280DS the right size for you?

✓ Yes, if…

✕ Buy something else if…

Film In, Stand-Up Pouch Out

The machine unwinds printed film, punches the bottom, folds it into a stand-up pouch, seals the bottom and sides, and cuts it off — then opens it, fills it and seals the top. No pouch magazine to refill and no pouches bought in.

Servo Film Advance

A servo pulls the film forward with enough torque for large pouches, and holds the pull even as the roll gets lighter. Pouch length is changed on the touchscreen.

Registration to Your Printed Film

A photocell reads the registration mark on your printed film and corrects the feed, so the artwork lands in the same place on every pouch.

Independent Zipper Unwind

On the zipper version, the zipper comes off its own reel with its own tension control and is sealed into the pouch as it forms — flat, without the puckering that comes from pulling it at the same tension as the film.

Two Filling Stations and a Vibrator

The dose goes in over two stations, with the pouch vibrated between them so powder settles before the second fill. A light powder that would otherwise overflow the pouch mouth has somewhere to go.

Heat Seal, Then Cooling Seal

The top is sealed by heated jaws, then pressed by cooling jaws before the pouch leaves the machine. Setting the seal while it’s still under pressure is what keeps it flat.

Technical specification

ParameterAPK-280DSWhat it means for you
OutputTwo pouches per cycle—
Pouch width90–140 mm per laneTwin output halves the width available to each pouch
Pouch length110–250 mm—
Pouch volume600 ml per pouchVolume, not weight
Speed90–120 pouches/min—
Pouch typesStand-up, shaped, hanging hole; zipper on the DSZ version—
Power15.5 kWThe highest in the range
Air400 NL/min—
Dimensions10,120 × 1,210 × 1,500 mmThe longest line we build
Weight3,200 kgCheck your floor loading

Model comparison

Model

Pouch width

Max fill

Speed

Power

Length

APK-130S

60–130 mm

200 ml

35–45/min

6 kW

4.5 m

APK-180S

90–180 mm

1,000 ml

40–60/min

9 kW

6.0 m

APK-240S

100–240 mm

1,500 ml

40–60/min

11 kW

8.7 m

APK-280DS

90–140 mm

600 ml

90–120/min

15.5 kW

10.1 m

Every machine in this group makes the pouch from roll film. If you'd rather buy printed pouches, see our premade pouch machines — shorter, lower power, and a size change is an adjustment.

Industry Applications

Single-flavour drink mix pouches at volume

One product, one pouch size, run continuously .

Collagen and creatine

Fine powders in mid-size stand-up pouches, where output per shift decides the margin. 

Electrolyte and probiotic granules

Free-flowing granules on volumetric cups, one per lane. 

Contract packing a high-volume SKU

A client product that runs every week in the same pouch.

What changing over involves

What changed

What you adjust

Roughly

Same pouch, new film roll

Splice the new roll

15-30 Minutes

Pouch length

Touchscreen setting

15-30 Minutes

Pouch width

60 mm–130 mm

15-30 Minutes

Powder → granule

Dosing unit — auger to cup

15-30 Minutes

A roll-film machine earns its keep running one size for a long time. If you change size weekly, that’s what premade pouch machines are for.

What to check before you buy

01

What a size change costs you

On a roll-film machine, find out what changes when your pouch width changes — a setting or a set of parts — and how long it takes. That's the number that decides whether buying film pays off.

02

Your film, not theirs

Every supplier's speed was measured on some film. Send yours and ask for the rate they held on it.

03

Installation and training

Ask what's included and what costs extra.

Why Buy From AIPAK?

One Point of Contact
You deal with us for the machine, the change parts, the installation and the service call. If something goes wrong on your floor, there’s one number to ring and one team responsible for fixing it — not a machine supplier and an installer pointing at each other.

We Run Your Product Before You Order
Every supplier quotes a speed and an accuracy figure, and those were measured on somebody’s product — probably not yours. Running your own sample is the only way to know what the machine will actually do on it.

A U.S. Number, Answered by Us
+1 (213) 526-8644 — phone or WhatsApp, 9am to 11pm Eastern, Monday to Friday. That’s 6am to 8pm Pacific, so it covers a full working day anywhere in the continental U.S. Outside those hours and at weekends, message us and we’ll come back at the start of the next window. We’d rather tell you that than claim 24/7 and not answer.

Spare Parts and Lead Time, in Writing
Wear parts are listed and priced in your quote before you sign, so you know what the first year costs. Lead time is confirmed in writing with your order — not estimated on a call.

APK-280DS Doypack Sealing Machine FAQ

How does twin output double the rate?

Two lanes of film form, fill and seal side by side. The machine indexes once and produces two pouches, so output goes to 90–120 a minute without running faster.

Why is the pouch narrower than on the single-lane machines?

Two pouches share the machine’s width, so each lane takes up to 140 mm. If your pouch is wider, the APK-180S or APK-240S is the machine.

Is the zipper made into the pouch?

Yes, on the zipper version — from its own reel, on each lane.

How much floor and power does it need?

10.1 m of line, 15.5 kW and 400 NL/min of compressed air. It’s the largest machine in our roll-film range.

Roll film or premade pouches?

Roll film pays off when one size runs for long stretches. For several sizes, see our premade pouch machines. [See premade pouch machines →]

Customers Also Interested In...

Send Us Your Film Spec and a Powder Sample

Three things decide whether this machine pays off for you. Your pouch has to be 60 to 130 mm wide and hold up to 200 ml. You need 4.5 m of floor for the line. And you should be running one pouch size for long stretches — roll film costs less per bag than a premade pouch, but that saving only adds up when the size stays put.

Send us your film spec and a sample of your powder. We’ll form, fill and seal pouches from it and send them back, so you see the seal, the stand-up bottom and the fill weight on your own material before you order. If you run several sizes, we’ll tell you honestly that a premade pouch machine may suit you better.

  • Reply within one business day
  • Your film and powder run on the machine before you order
  • Your formula and artwork stay with us

No sales calls — we reply by email or WhatsApp, whichever you gave us.

Scroll to Top