APK-240S Doypack Machine — Large Stand-Up Pouches from Roll Film, up to 240 mm
The largest pouch in our roll-film range — with or without a zipper
A large stand-up pouch is where film saves the most, because a big printed pouch is the most expensive one to buy in. This machine forms it from film, fills it over two stations and seals it — up to 240 mm wide and 1,500 ml. It’s also 8.7 m long, so measure your floor first.
1. Pouch size: 100 to 240 mm wide, 120 to 320 mm long, the largest in the range
2. Zipper version: zipper unwound from its own reel and sealed in as the pouch forms
3. Two filling stations: with a vibrator between them
4. Line length: 8.7 m, 11 kW
Is the APK-240S the right size for you?
✓ Yes, if…
- Your pouch is wider than 180 mm and you run it for long stretches
- Large printed pouches are a real line item on your cost sheet
- You have 8.7 m of floor and 11 kW at this station
✕ Buy something else if…
- Your pouch is 180 mm or under → the APK-180S is 2.7 m shorter
- You run several pouch sizes → a premade pouch machine changes size with an adjustment
- Your floor can't take 8.7 m → see our premade pouch machines, most under 3.5 m
- Your product is a liquid or a gel → we build these machines for powders and granules
Film In, Stand-Up Pouch Out
The machine unwinds printed film, punches the bottom, folds it into a stand-up pouch, seals the bottom and sides, and cuts it off — then opens it, fills it and seals the top. No pouch magazine to refill and no pouches bought in.
Servo Film Advance
A servo pulls the film forward with enough torque for large pouches, and holds the pull even as the roll gets lighter. Pouch length is changed on the touchscreen.
Registration to Your Printed Film
A photocell reads the registration mark on your printed film and corrects the feed, so the artwork lands in the same place on every pouch.
Independent Zipper Unwind
On the zipper version, the zipper comes off its own reel with its own tension control and is sealed into the pouch as it forms — flat, without the puckering that comes from pulling it at the same tension as the film.
Two Filling Stations and a Vibrator
The dose goes in over two stations, with the pouch vibrated between them so powder settles before the second fill. A light powder that would otherwise overflow the pouch mouth has somewhere to go.
Heat Seal, Then Cooling Seal
The top is sealed by heated jaws, then pressed by cooling jaws before the pouch leaves the machine. Setting the seal while it’s still under pressure is what keeps it flat.
Technical specification
Parameter | APK-240S | What it means for you |
Pouch width | 100–240 mm | The largest in the roll-film range |
Pouch length | 120–320 mm | — |
Pouch volume | 1,500 ml | Volume, not weight |
Speed | 40–60 pouches/min | — |
Pouch types | Stand-up, shaped, hanging hole; zipper on the Z version | — |
Power | 11 kW | — |
Frequency / voltage | 60 Hz, built to your U.S. supply | We confirm the voltage with your quote |
Air | 400 NL/min | — |
Dimensions | 8,700 × 1,250 × 1,550 mm | Measure your floor first |
Weight | 2,800 kg | — |
Model comparison
Model | Pouch width | Max fill | Speed | Power | Length |
APK-130S | 60–130 mm | 200 ml | 35–45/min | 6 kW | 4.5 m |
APK-180S | 90–180 mm | 1,000 ml | 40–60/min | 9 kW | 6.0 m |
APK-240S | 100–240 mm | 1,500 ml | 40–60/min | 11 kW | 8.7 m |
APK-280DS | 90–140 mm | 600 ml | 90–120/min | 15.5 kW | 10.1 m |
Every machine in this group makes the pouch from roll film. If you'd rather buy printed pouches, see our premade pouch machines — shorter, lower power, and a size change is an adjustment.
Industry Applications
Protein in 2 lb zipper pouches
Large pouches, where film saves the most per bag.
Meal replacement and mass gainer
Large fills in one size, run for weeks
Greens and fiber blends
Bulky, low-density powders that need a big pouch for their weight
Bulk granules
Free-flowing granules on a volumetric cup
What changing over involves
What changed | What you adjust | Roughly |
Same pouch, new film roll | Splice the new roll | A few minutes |
Pouch length | Touchscreen setting | 15–30 minutes |
Pouch width | Change the forming set | 15–30 minutes |
Powder → granule | Dosing unit — auger to cup | 15–30 minutes |
A roll-film machine earns its keep running one size for a long time. If you change size weekly, that’s what premade pouch machines are for.
What to check before you buy
What a size change costs you
On a roll-film machine, find out what changes when your pouch width changes — a setting or a set of parts — and how long it takes. That's the number that decides whether buying film pays off.
Your film, not theirs
Every supplier's speed was measured on some film. Send yours and ask for the rate they held on it.
Installation and training
Ask what's included and what costs extra.
Why Buy From AIPAK?
One Point of Contact
One project engineer handles your machine from proposal to commissioning, so you’re not chasing five suppliers for one answer.
We Run Your Film and Powder Before You Order
Send us your film spec and a sample of your powder. We form, fill and seal pouches from it and send them back. You decide whether to talk quotes after that.
A U.S. Number, Answered by Us
+1 (213) 526-8644, answered by our engineers 9 AM–7 PM China time, Monday to Friday. That’s evening and overnight in the U.S., so leave a message or send a WhatsApp anytime and we’ll pick it up first thing.
Spare Parts and Lead Time, in Writing
A kit of wear parts ships with your machine. Every part in the kit, and the lead time for anything outside it, is listed in your quote in writing.
APK-240S Large-Volume Doypack Packaging Machine FAQ
Yes, the APK-240S is specialized for big-volume requirements, supporting pouch widths from 100mm to 240mm and volumes up to 1500ml.
The APK-240S follows the same core process, but utilizes larger forming components and a longer machine frame to handle the weight and dimensions of big-volume pouches to handle the weight and size of big-volume pouches.
Pouch length is a touchscreen setting. Pouch width means changing the forming set, which takes longer. If you change pouch size often, a premade pouch machine suits you better.
It draws 11 kW, so check the supply at this station before you plan the line. We build to your U.S. supply at 60 Hz and confirm the voltage with your quote.
Yes, on the zipper version. The zipper comes off its own reel with its own tension control and is sealed in as the pouch forms.
Roll film if one size runs for long stretches and pouch cost matters. Premade pouches if you run several sizes. [See premade pouch machines →]
A kit of wear parts ships with your machine. Every part in the kit, and the lead time for anything outside it, is listed in your quote in writing.
Customers Also Interested In...
Send Us Your Film Spec and a Powder Sample
Three things decide whether this machine pays off for you. Your pouch has to be 100 to 240 mm wide and hold up to 1,500 ml. You need 8.7 m of floor for the line. And you should be running one pouch size for long stretches — roll film costs less per bag than a premade pouch, but that saving only adds up when the size stays put.
Send us your film spec and a sample of your powder. We’ll form, fill and seal pouches from it and send them back, so you see the seal, the stand-up bottom and the fill weight on your own material before you order. If you run several sizes, we’ll tell you honestly that a premade pouch machine may suit you better.
- Reply within one business day
- Your film and powder run on the machine before you order
- Your formula and artwork stay with us
No sales calls — we reply by email or WhatsApp, whichever you gave us.